3d-robotics Pixhawk Autopilot Manual de usuario descargar pdf (Pagina 2)

PARTS

1 Pixhawk

2 Buzzer

3 Safety switch

4 Micro-SD card and adapter

5 Micro-USB cable

6 Six-wire cable x2

7 Power module

8 I

C splitter module

9 Four-position I

C splitter cable

10 Three-wire servo cable

11 Mounting foam

1 2 3 4 5 7

MOUNT

Use the provided foam to mount Pixhawk as close as possible to your vehicle’s center of gravity.

Make sure to orient the board with the arrow pointing forward.

Vehicle front

Attach the foam squares to the

corners of the board.

GETTING STARTED

With the help of APM firmware, Pixhawk turns any

RC plane, copter, or rover into a full-featured personal

drone. Once you have a fully-assembled frame, follow

this guide to install Pixhawk.

1 Mount

2 Connect

3 Load firmware

4 Calibrate

1 2 3 4 5 6 7 ... 13 14

Sin comentarios

3d-robotics Pixhawk Autopilot Manual de usuario Pagina 2