3d-robotics Digital Airspeed Sensor Manual de usuario descargar pdf (Pagina 2)

Connect to Pixhawk

Connect the four-wire cable to Pixhawk’s I

C port or I

C splitter.

Pixhawk I

C splitter

Mount

Mount the pitot tube parellel to the fuselage of your aircraft, facing into the wind,

at least 1.5 inches away from the fuselage. Make sure the rubber tubing isn’t bent

to an extent that the air is restricted from ﬂowing freely within the tube.

Check out this 3D-printed mount at Thingiverse.

1 2 3

Sin comentarios

3d-robotics Digital Airspeed Sensor Manual de usuario Pagina 2