3d-robotics Digital Airspeed Sensor Manual de usuario descargar pdf (Pagina 1)

PIXHAWK DIGITAL AIRSPEED SENSOR

Digital airspeed sensor

Pitot tube Rubber tubing

Assemble

Four-wire I

C cable

Connect the four-wire cable to the four-position port on the airspeed sensor.

Cut the piece of rubber tubing in half. You should have two pieces of equal length.

Attach a piece to each of the input sensor cones on the board.

Connect the tube attached to the cone on the top of the board to the longer

extension on the pitot tube, and connect the tube attached to the cone on the

main, lower section of the board to the smaller extention on the pitot tube.

pitot tube

complete assembly

sensor cones

1 2 3

Indice de contenidos

Pagina 1 - Assemble

PIXHAWK DIGITAL AIRSPEED SENSORDigital airspeed sensorPitot tube Rubber tubingAssembleFour-wire I2C cableConnect the four-wire cable to the four-posit

Pagina 2 - Connect to Pixhawk

Connect to PixhawkConnect the four-wire cable to Pixhawk’s I2C port or I2C splitter.Pixhawk I2C splitterMountMount the pitot tube parellel to the fuse

Pagina 3 - Speciﬁcations

ConﬁgurationTo enable the airspeed sensor, connect Pixhawk to Mission Planner (or APM Planner for OS X), and select the Advanced Parameter List under

Comentarios a estos manuales

Sin comentarios

3d-robotics Digital Airspeed Sensor Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Sensores 3d-robotics Digital Airspeed Sensor. 3D Robotics Digital Airspeed Sensor User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales